Vip3r is my second Tricopter after i made some flying experiences with Splint3r, my first tricopter.
With Vip3r I used this experiences and fixed mistakes I made in building splinter.
More under http://vip3rcopter.blogspot.com
Chassis:[]
- Tricopter with rear Servo
- 1,4mm GRP (glass reinforced plastic) aluminium Arms
- overall wheight: 900g
- radius (center-motor): 22,5cm
Electronics[]
- Controller: TRIGuide mini by W. Thielicke
- Gyros: 3x Sparkfun: ADXR610
- TX/RX: Robbe Futaba F-14
- Motors: Turnigy TR C2830
- ESC: Mystery Pentium 30A
- Propellers: Maxxprod 045
- Servo: Turnigy TGY-90s (Metal Gear Servo)
- Battery: Rhino 2100mAh, Turnigy 2200mAh
Modifications[]
- buzzer for low battery warning and receiver problems
- automatic inflight XY-offset calibration
- additional 12V output on Controller board